• If the Mac Pro is running, shut it down before proceeding. • Disconnect any cables that are connected to the Mac Pro, except the power cord. The power cord must be connected, so you can discharge any static buildup through the power cord and into its grounded outlet. • Discharge any static electricity that has built up on your body by touching the PCI expansion slot cover plates. You'll find these metal plates on the back of the Mac Pro, next to the DVI video connectors for the display. You may feel a slight static shock when you touch the metal cover plates. This is normal; there's no need to be concerned for yourself or the Mac Pro. • Remove the power cord from the Mac Pro. • Ensure that the access latch on the back of the Mac Pro is in the up position. Buy OWC / Other World Computing 2.5' Drive Sled for 2009-2012 Apple Mac Pro featuring Supports Installation of 2.5' Hard Drive, For Apple Mac Pro. Amazon.com: 2nd 2.5' SATA HDD SSD Hard Drive Disk DVD CD ROM Optical SuperDrive Caddy Tray Adapter for Apple Unibody Macbook / Macbook Pro 13. May 28, 2014 The guide screws attached to the side of the hard drive, that slide into the rubber guides, are very nice to have, but they can be used without the thin sled. I have installed some hard drives without a sled, and just the guide screws. The access latch not only locks the access panel, it also locks the hard drive sleds in place. If the latch isn't up, you won't be able to insert or remove a hard drive sled. • Pick the hard drive sled you want to use. The sleds are numbered one through four, with the number one sled near the front of the Mac Pro, and the number four sled at the rear. Sky a860 usb drivers for mac. There is no significance to the positions or numbers, except that Apple uses the number one sled as the default location for a hard drive installation. This might seem tricky the first time you do it. Just let your fingers curl around the bottom of the sled, and then pull it towards you. • Now that the new hard drive is attached to the sled, align the sled with the drive bay opening and gently push the sled into place, so that it's flush with the other sleds. • To reinstall the access panel, put the bottom of the panel into the Mac Pro, so that the set of tabs on the bottom of the panel catch the lip at the bottom of the Mac Pro. Once everything is aligned, tilt the panel up and into position. • Close the access latch on the back of the Mac Pro. This will lock the hard drive sleds in place, as well as lock the access panel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |